News & Events

With Paint For Pros BeamerPaint, any (smooth) surface can easily be
made suitable for beamer projection. This paint can also be applied to
large and unusual surfaces, which can then be converted into a high
quality presentation wall.
PERFORMANCE
BeamerPaint consists of a primer and a finish. After applying two
layers of BeamerPaint Primer, the surface has to be optimised with our
BeamerPaint Finish. This finish provides a hard but smooth top layer,
which makes the projection sharp and rich in contrast.
USAGE
Before the projector paint can be applied, the surface must be stable
(weight bearing), dry and clean. The subsurface must comply with
the requirements set for gypsum substrates (level 4), or at least with a
comparable classification.
The paint can easily be applied with a paint roller. The primer must dry
for at least 5 to 6 hours after the first layer has been applied. Before the
finish can be applied, the same drying time must be allowed.
TIP
Rollers and paint trays which have been used can easily be cleaned with
water immediately after using BeamerPaint.
SHEEN Satin finish
COLOUR White
DENSITY Basecoat 1,45g/cm3 - Finishcoat 1,02 g/cm3
FILM THICKNESS Ca 200 μm dry film
THEORETICAL COVERAGE Base: 5 m²/L, one coat. Finish:10 m²/L, one coat
VISCOSITY Ready for use. If required, only solve primer with a
maximum of 5% clear water.
SPRAYABLE Yes
VOC EU limit value for this product (2004/42/EC, cat. iSB,
2010): 30 g/l. This product contains: <1 gr./L VOC’s.
APPLICATION Surface and air temperature should be between 16-
26°C / 60-80°F.
DRYING TIME
TOUCH DRY After 2-3 hours @ 20°C and
65 % relative humidity
RECOATABLE After 5-6 hours @ 20°C and
65 % relative humidity
READY TO USE After 48 hours @ 20°C and
65 % relative humidity
PACKAGING 2 L Primer, 1 L Finish
SHELF LIFE
Minimum 12 months, if stored in a cool dry area
between temperatures of 5-35°C /40-75°F and keep
out of direct sun light, sealed tightly